|
NAME | SYNOPSIS | DESCRIPTION | NOTES | BUGS | SEE ALSO | COLOPHON |
|
NETDEVICE(7) Linux Programmer's Manual NETDEVICE(7)
netdevice - low-level access to Linux network devices
#include <sys/ioctl.h>
#include <net/if.h>
This man page describes the sockets interface which is used to
configure network devices.
Linux supports some standard ioctls to configure network devices.
They can be used on any socket's file descriptor regardless of the
family or type. Most of them pass an ifreq structure:
struct ifreq {
char ifr_name[IFNAMSIZ]; /* Interface name */
union {
struct sockaddr ifr_addr;
struct sockaddr ifr_dstaddr;
struct sockaddr ifr_broadaddr;
struct sockaddr ifr_netmask;
struct sockaddr ifr_hwaddr;
short ifr_flags;
int ifr_ifindex;
int ifr_metric;
int ifr_mtu;
struct ifmap ifr_map;
char ifr_slave[IFNAMSIZ];
char ifr_newname[IFNAMSIZ];
char *ifr_data;
};
};
Normally, the user specifies which device to affect by setting
ifr_name to the name of the interface. All other members of the
structure may share memory.
Ioctls
If an ioctl is marked as privileged, then using it requires an effec‐
tive user ID of 0 or the CAP_NET_ADMIN capability. If this is not
the case, EPERM will be returned.
SIOCGIFNAME
Given the ifr_ifindex, return the name of the interface in
ifr_name. This is the only ioctl which returns its result in
ifr_name.
SIOCGIFINDEX
Retrieve the interface index of the interface into
ifr_ifindex.
SIOCGIFFLAGS, SIOCSIFFLAGS
Get or set the active flag word of the device. ifr_flags con‐
tains a bit mask of the following values:
Device flags
IFF_UP Interface is running.
IFF_BROADCAST Valid broadcast address set.
IFF_DEBUG Internal debugging flag.
IFF_LOOPBACK Interface is a loopback interface.
IFF_POINTOPOINT Interface is a point-to-point link.
IFF_RUNNING Resources allocated.
IFF_NOARP No arp protocol, L2 destination address not
set.
IFF_PROMISC Interface is in promiscuous mode.
IFF_NOTRAILERS Avoid use of trailers.
IFF_ALLMULTI Receive all multicast packets.
IFF_MASTER Master of a load balancing bundle.
IFF_SLAVE Slave of a load balancing bundle.
IFF_MULTICAST Supports multicast
IFF_PORTSEL Is able to select media type via ifmap.
IFF_AUTOMEDIA Auto media selection active.
IFF_DYNAMIC The addresses are lost when the interface
goes down.
IFF_LOWER_UP Driver signals L1 up (since Linux 2.6.17)
IFF_DORMANT Driver signals dormant (since Linux 2.6.17)
IFF_ECHO Echo sent packets (since Linux 2.6.25)
Setting the active flag word is a privileged operation, but any
process may read it.
SIOCGIFPFLAGS, SIOCSIFPFLAGS
Get or set extended (private) flags for the device. ifr_flags
contains a bit mask of the following values:
Private flags
IFF_802_1Q_VLAN Interface is 802.1Q VLAN device.
IFF_EBRIDGE Interface is Ethernet bridging device.
IFF_SLAVE_INACTIVE Interface is inactive bonding slave.
IFF_MASTER_8023AD Interface is 802.3ad bonding master.
IFF_MASTER_ALB Interface is balanced-alb bonding master.
IFF_BONDING Interface is a bonding master or slave.
IFF_SLAVE_NEEDARP Interface needs ARPs for validation.
IFF_ISATAP Interface is RFC4214 ISATAP interface.
Setting the extended (private) interface flags is a privileged opera‐
tion.
SIOCGIFADDR, SIOCSIFADDR
Get or set the address of the device using ifr_addr. Setting
the interface address is a privileged operation. For compati‐
bility, only AF_INET addresses are accepted or returned.
SIOCGIFDSTADDR, SIOCSIFDSTADDR
Get or set the destination address of a point-to-point device
using ifr_dstaddr. For compatibility, only AF_INET addresses
are accepted or returned. Setting the destination address is
a privileged operation.
SIOCGIFBRDADDR, SIOCSIFBRDADDR
Get or set the broadcast address for a device using
ifr_brdaddr. For compatibility, only AF_INET addresses are
accepted or returned. Setting the broadcast address is a
privileged operation.
SIOCGIFNETMASK, SIOCSIFNETMASK
Get or set the network mask for a device using ifr_netmask.
For compatibility, only AF_INET addresses are accepted or
returned. Setting the network mask is a privileged operation.
SIOCGIFMETRIC, SIOCSIFMETRIC
Get or set the metric of the device using ifr_metric. This is
currently not implemented; it sets ifr_metric to 0 if you
attempt to read it and returns EOPNOTSUPP if you attempt to
set it.
SIOCGIFMTU, SIOCSIFMTU
Get or set the MTU (Maximum Transfer Unit) of a device using
ifr_mtu. Setting the MTU is a privileged operation. Setting
the MTU to too small values may cause kernel crashes.
SIOCGIFHWADDR, SIOCSIFHWADDR
Get or set the hardware address of a device using ifr_hwaddr.
The hardware address is specified in a struct sockaddr.
sa_family contains the ARPHRD_* device type, sa_data the L2
hardware address starting from byte 0. Setting the hardware
address is a privileged operation.
SIOCSIFHWBROADCAST
Set the hardware broadcast address of a device from
ifr_hwaddr. This is a privileged operation.
SIOCGIFMAP, SIOCSIFMAP
Get or set the interface's hardware parameters using ifr_map.
Setting the parameters is a privileged operation.
struct ifmap {
unsigned long mem_start;
unsigned long mem_end;
unsigned short base_addr;
unsigned char irq;
unsigned char dma;
unsigned char port;
};
The interpretation of the ifmap structure depends on the
device driver and the architecture.
SIOCADDMULTI, SIOCDELMULTI
Add an address to or delete an address from the device's link
layer multicast filters using ifr_hwaddr. These are privi‐
leged operations. See also packet(7) for an alternative.
SIOCGIFTXQLEN, SIOCSIFTXQLEN
Get or set the transmit queue length of a device using
ifr_qlen. Setting the transmit queue length is a privileged
operation.
SIOCSIFNAME
Changes the name of the interface specified in ifr_name to
ifr_newname. This is a privileged operation. It is allowed
only when the interface is not up.
SIOCGIFCONF
Return a list of interface (transport layer) addresses. This
currently means only addresses of the AF_INET (IPv4) family
for compatibility. Unlike the others, this ioctl passes an
ifconf structure:
struct ifconf {
int ifc_len; /* size of buffer */
union {
char *ifc_buf; /* buffer address */
struct ifreq *ifc_req; /* array of structures */
};
};
If ifc_req is NULL, SIOCGIFCONF returns the necessary buffer
size in bytes for receiving all available addresses in
ifc_len. Otherwise, ifc_req contains a pointer to an array of
ifreq structures to be filled with all currently active L3
interface addresses. ifc_len contains the size of the array
in bytes. Within each ifreq structure, ifr_name will receive
the interface name, and ifr_addr the address. The actual num‐
ber of bytes transferred is returned in ifc_len.
If the size specified by ifc_len is insufficient to store all
the addresses, the kernel will skip the exceeding ones and
return success. There is no reliable way of detecting this
condition once it has occurred. It is therefore recommended
to either determine the necessary buffer size beforehand by
calling SIOCGIFCONF with ifc_req set to NULL, or to retry the
call with a bigger buffer whenever ifc_len upon return differs
by less than sizeof(struct ifreq) from its original value.
If an error occurs accessing the ifconf or ifreq structures,
EFAULT will be returned.
Most protocols support their own ioctls to configure protocol-spe‐
cific interface options. See the protocol man pages for a descrip‐
tion. For configuring IP addresses, see ip(7).
In addition, some devices support private ioctls. These are not
described here.
Strictly speaking, SIOCGIFCONF and the other ioctls that accept or
return only AF_INET socket addresses, are IP-specific and belong in
ip(7).
The names of interfaces with no addresses or that don't have the
IFF_RUNNING flag set can be found via /proc/net/dev.
Local IPv6 IP addresses can be found via /proc/net or via
rtnetlink(7).
glibc 2.1 is missing the ifr_newname macro in <net/if.h>. Add the
following to your program as a workaround:
#ifndef ifr_newname
#define ifr_newname ifr_ifru.ifru_slave
#endif
proc(5), capabilities(7), ip(7), rtnetlink(7)
This page is part of release 4.15 of the Linux man-pages project. A
description of the project, information about reporting bugs, and the
latest version of this page, can be found at
https://www.kernel.org/doc/man-pages/.
Linux 2017-09-15 NETDEVICE(7)
Pages that refer to this page: ioctl_list(2), getifaddrs(3), ip(7), ipv6(7), packet(7)
Copyright and license for this manual page
|
HTML rendering created 2018-02-02 by Michael Kerrisk, author of The Linux Programming Interface, maintainer of the Linux man-pages project. For details of in-depth Linux/UNIX system programming training courses that I teach, look here. Hosting by jambit GmbH.
|
|