Last reviewed: 04/04/2016 HPE iLO NMI Watchdog Driver NMI sourcing for iLO based ProLiant Servers Documentation and Driver by Thomas Mingarelli The HPE iLO NMI Watchdog driver is a kernel module that provides basic watchdog functionality and the added benefit of NMI sourcing. Both the watchdog functionality and the NMI sourcing capability need to be enabled by the user. Remember that the two modes are not dependent on one another. A user can have the NMI sourcing without the watchdog timer and vice-versa. All references to iLO in this document imply it also works on iLO2 and all subsequent generations. Watchdog functionality is enabled like any other common watchdog driver. That is, an application needs to be started that kicks off the watchdog timer. A basic application exists in the Documentation/watchdog/src directory called watchdog-test.c. Simply compile the C file and kick it off. If the system gets into a bad state and hangs, the HPE ProLiant iLO timer register will not be updated in a timely fashion and a hardware system reset (also known as an Automatic Server Recovery (ASR)) event will occur. The hpwdt driver also has three (3) module parameters. They are the following: soft_margin - allows the user to set the watchdog timer value. Default value is 30 seconds. allow_kdump - allows the user to save off a kernel dump image after an NMI. Default value is 1/ON nowayout - basic watchdog parameter that does not allow the timer to be restarted or an impending ASR to be escaped. Default value is set when compiling the kernel. If it is set to "Y", then there is no way of disabling the watchdog once it has been started. NOTE: More information about watchdog drivers in general, including the ioctl interface to /dev/watchdog can be found in Documentation/watchdog/watchdog-api.txt and Documentation/IPMI.txt. The NMI sourcing capability is disabled by default due to the inability to distinguish between "NMI Watchdog Ticks" and "HW generated NMI events" in the Linux kernel. What this means is that the hpwdt nmi handler code is called each time the NMI signal fires off. This could amount to several thousands of NMIs in a matter of seconds. If a user sees the Linux kernel's "dazed and confused" message in the logs or if the system gets into a hung state, then the hpwdt driver can be reloaded. 1. If the kernel has not been booted with nmi_watchdog turned off then edit and place the nmi_watchdog=0 at the end of the currently booting kernel line. Depending on your Linux distribution and platform setup: For non-UEFI systems /boot/grub/grub.conf or /boot/grub/menu.lst For UEFI systems /boot/efi/EFI/distroname/grub.conf or /boot/efi/efi/distroname/elilo.conf 2. reboot the sever 3. Once the system comes up perform a modprobe -r hpwdt 4. modprobe /lib/modules/`uname -r`/kernel/drivers/watchdog/hpwdt.ko Now, the hpwdt can successfully receive and source the NMI and provide a log message that details the reason for the NMI (as determined by the HPE BIOS). Below is a list of NMIs the HPE BIOS understands along with the associated code (reason): No source found 00h Uncorrectable Memory Error 01h ASR NMI 1Bh PCI Parity Error 20h NMI Button Press 27h SB_BUS_NMI 28h ILO Doorbell NMI 29h ILO IOP NMI 2Ah ILO Watchdog NMI 2Bh Proc Throt NMI 2Ch Front Side Bus NMI 2Dh PCI Express Error 2Fh DMA controller NMI 30h Hypertransport/CSI Error 31h -- Tom Mingarelli (thomas.mingarelli@hpe.com)