*****************************************************************************
* These files are used	    *	
* to enumerate 8x930HX device using the debugger from PLC software and Keil *
* software.  								    *
*****************************************************************************

* To use this code just open the software tool that is to be used 
  and open the project file that is included with the zip file using the 	
  OPEN PROJECT command.
	- *.PRO extension for PLC
	- *.PRJ extension for Keil  

* Change all source files in the project source files so that the 
  source files path reflects the path of the project.  This is a very important step,
  make sure that when you open the project you check all path options, you may need
  to add and remove source files/include files from the project in order to get the
  paths correct on your system.
  
* Go into each of the individual source files and near the top there will
  be a couple of EQU statements for each of the Software tools that this project
  can be assembled under.  Also go into SWITCH.INC for other various switches
  that MUST be set for things to work right.

* Place a 1 with the assembler that is to be used and a 0 with the other assembler.  
  
* Build the project and download to the debugger.  Note that you need to change LINK
  options when switching between RISM and ROM, the code has comments describing each,

* The evaluation board is now ready to be enumerated once the code begins executing.

* NOTE that not all of the code found in these files is required for basic operation, 
  there are many routines in this code used for internal validation purposes.

FILES INCLUDED:

readme.txt:	this file
hub_rism.pro:	PLC project file
h930frmw.prj:	KEIL project file
hub_ep0.asm:	mainly Chpt9 commands for hub
hub_firm.asm:	mainly Chpt11 commands for hub
sv_code.asm:	mainly validation tests and function routines
emb_func.asm:	mainly Chpt9 commands for the function and loopback code
one_oh.inc:	include file, used by both Keil/PLC
switch.in:	include file, ised by both Keil/PLC contains switches
8x930ax.inc:	PLC 930 include file (Keil can use the one that comes with Keil)
8x930hx.inc:	PLC 930 include file (Keil can use the one that comes with Keil)
dscope.ini:	debugger init file for Keil